Nissan Maxima Service and Repair Manual: DTC/circuit diagnosis

Diagnosis system (BCM)

COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the fo ...

Power supply and ground circuit

BCM BCM : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnec ...

Other materials:

Sunroof motor assembly
Removal and Installation REMOVAL CAUTION: Before removing sunroof motor, check that glass lid is fully closed. After removing sunroof motor, do not attempt to rotate sunroof motor assembly as a single unit. Close glass lid. Remove the headlining. Refer to INT-33, "Removal a ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

Trouble diagnosis - specification value
Description The specification (SP) value indicates the tolerance of the value that is displayed in "SPEC" of "DATA MONITOR" mode of CONSULT during normal operation of the Engine Control System. When the value in "SPEC" in "DATA MONITOR" mode is NOT within the SP value, the Engine Control Sy ...