BCM (BODY CONTROL MODULE)
Removal and Installation
For removal and installation of the BCM.
PUSH BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
Microphone signal circuit
Description
Voice signals are transmitted from the microphone to the Bluetooth control
unit using the microphone signal circuits.
Diagnosis Procedure
1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE
Turn ignition switch OFF.
Disconnect Bluetooth control unit connector and ...
Changing engine oil filter
1. Park the vehicle on a level surface and apply
the parking brake.
2. Turn the engine off.
3. Place a large drain pan under the oil filter B .
4. Remove clips A from the right engine protector
located inside the right wheel well and
then remove protector. Remove oil filter B
with an ...
Ignition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTIO ...