Nissan Maxima Service and Repair Manual: IPDM E/R (intelligent power distribution module engine room)

Fuse, fusible link and relay box

Terminal Arrangement ...

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", ...

Other materials:

Condenser
Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of ...

Camshaft Valve Clearance
Valve Clearance CHECKING NOTE: Perform inspection as follows after removal, installation or replacement of camshaft or valve related parts, or if there are unusual engine conditions regarding valve clearance. Check valve clearance while engine is cold and not running. Remove th ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...