Nissan Maxima Service and Repair Manual: The parking brake release warning continues displaying, or does not display

Nissan Maxima Service and Repair Manual / Driver information & multimedia / Meter, warning lamp & indicator / Symptom diagnosis / The parking brake release warning continues displaying, or does not display

Description

  •  The parking brake warning is displayed while driving the vehicle even though the parking brake is released.

  •  The parking brake warning is not displayed even though driving the vehicle with the parking brake depressed.

Diagnosis Procedure

1.CHECK PARKING BRAKE WARNING LAMP OPERATION

  1.  Start engine.

  2.  Monitor "BRAKE" warning lamp while applying and releasing the parking brake.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

  1.  Turn ignition switch OFF.

  2.  Check the parking brake switch signal circuit. Refer to MWI-44, "Diagnosis Procedure".

3.CHECK PARKING BRAKE SWITCH UNIT

Perform a unit check for the parking brake switch. Refer to MWI-44, "Component Inspection".

    The oil pressure warning lamp does not turn off
    Description The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure). Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-87, "Wiri ...

    The low washer fluid warning continues displaying, or does not display
    Description  The warning is still displayed even after washer fluid is added.  The warning is not displayed even though the washer tank is empty. Diagnosis Procedu ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for ...

    Headlamp (LO) circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM over the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 51 and 52, located in the IPDM E/R. Power then flows ...

    Antenna AMP
    Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.0054