Nissan Maxima Service and Repair Manual: U1010 control unit (CAN)

U1000 CAN comm circuit

Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

U1200 AV control unit

Description Part name  Description  AV CONTROL UNIT  It is the master unit of the MULTI AV system and it is connected to each control unit by means ...

Other materials:

B2617 starter relay circuit
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2617 is displ ...

Diagnosis system (IPDM E/R)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. Oil pressure warning lamp Front wiper (LO, HI) Parking lamps Side marker lamps License plate lamps Tail lamps Front f ...

U1010 control unit (CAN)
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. REPLACE BCM When DTC [U1010] is detected, replace BCM. Special Repair Requirement 1. REQUIRED WORK WHEN REPLACING BCM Initialize NVIS by CONSULT. For the details of initialization refer to CONSULT Immobilizer mode and follow the on ...