Nissan Maxima Service and Repair Manual: Antenna AMP.

Removal and Installation

REMOVAL

  1. Remove the rear pillar finisher RH. Refer to INT-36, "Exploded View".
  2. Detach the antenna amp. harness clip (A).
  3. Disconnect the harness connectors (B) from the antenna amp. (1).
  4. Remove the antenna amp. screw (C) and the antenna amp. (1).

Nissan Maxima. ANTENNA AMP.

INSTALLATION

Installation is in the reverse order of removal

    Audio antenna
    Location of Antenna AV control unit AV control unit antenna feeder In-line connectors M103, M501 Antenna amp. Window antenna Satellite radio antenna feeder Satellite radio ante ...

    Microphone
    Removal and Installation REMOVAL Remove the front room/map lamp assembly. Refer to INL-84, "Removal and Installation". Detach the microphone connector (A). Remove the fro ...

    Other materials:

    Headlamp
    System Diagram System Description Control of the headlamp system is dependent upon the position of the combination switch (lighting and turn signal switch). When the lighting switch is placed in the 2nd position, the BCM (body control module) receives input requesting the headlamps and par ...

    B2562 Low voltage
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION Erase DTC. Turn ignition switch OFF. Perform the "SELF-DIAG RESULTS" of BCM with CONSULT, after the ignition switch has been turned ON for 1.5 seconds or more. Diagnosis Procedure 1. CHECK ...

    Power distribution system
    System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION POWER DISTRIBUTION SYSTEM (PDS) is the system that BCM controls with the operation of the pushbutton ignition switch and performs the power distribution to each power circuit. This system is used instead of the mec ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.015