Nissan Maxima Service and Repair Manual: U1205 AV control unit

DTC Logic

Nissan Maxima. U1205 AV CONTROL UNIT

Diagnosis Procedure

1.PERFORM THE SELF-DIAGNOSIS

  1. Delete the "self-diagnosis" results of "MULTI AV". Turn ignition switch OFF.
  2. Turn ignition switch ON. Perform the self-diagnosis again.
  3. Check that the DTC is detected again.
    U1204 AV control unit
    DTC Logic Diagnosis Procedure 1.PERFORM THE SELF-DIAGNOSIS Delete the "self-diagnosis" results of "MULTI AV". Turn ignition switch OFF. Turn ignition switch ON. Perform the self-diagnos ...

    U1206 AV control unit
    DTC Logic Diagnosis Procedure 1.PERFORM THE SELF-DIAGNOSIS Delete the "self-diagnosis" results of "MULTI AV". Turn ignition switch OFF. Turn ignition switch ON. Perform the self-diagnos ...

    Other materials:

    Heated seat switches (if so equipped)
    The front seats are warmed by built-in heaters. 1. Start the engine. 2. Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate. The heater is controlled by a thermostat, automatically turning the heater on and off. The indicator light ...

    Seats
    WARNING Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and receive neck or other serious injuries. You could also slide under the lap belt and recei ...

    U1000 Can comm circuit
    Description DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure. Diagnosis Proc ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.0054