Nissan Maxima Owners Manual: System malfunction

System temporarily unavailable

Condition A When the radar sensor picks up interference from another radar source, making it impossible to detect a vehicle ahead, the PFCW system is automatically turned off. The FEB system wa ...

System maintenance

The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front ...

Other materials:

P0845 transmission fluid pressure SEN/SW B
Description The primary pressure sensor detects primary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 ...

NVIS (NISSAN vehicle immobilizer system-nats)
System Diagram System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION The NVIS (NATS) is an anti-theft system. By registering an Intelligent Key ID into the vehicle, it prevents the engine being started by an unregistered Intelligent Key. It has a higher protection again ...

STRG branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side). 2.CHECK HARNESS FOR OPE ...