Nissan Maxima Service and Repair Manual: Door mirror

Inside mirror

Wiring Diagram - Without Homelink Universal Transceiver Wiring Diagram - With Homelink Universal Transceiver ...

Symptom diagnosis

SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet ...

Other materials:

P050A, P050e cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A or P050E is dis ...

Antenna AMP
Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

DLC branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). 2.CHECK HARNESS FOR OP ...