Nissan Maxima Owners Manual: How to turn on and off predicted course lines

To toggleONand OFF the predicted course lines while in the P (Park) position: 1. Touch the Settings key.

2. Touch the Camera key.

3. Touch the Predicted Course Lines key to turn the feature ON or OFF.

To toggleONand OFF the predicted course lines while in the R (Reverse) position: 1. Touch the touch-screen display.

2. Touch the Predicted Course Lines key to turn the feature ON or OFF.

    Adjusting the screen
    1. While on a RearView Monitor screen, touch the touch-screen display. The Camera Settings screen will come up. 2. Touch the Display Settings key. 3. Touch the "Brightness," "Contrast," "T ...

    RearView Monitor system limitations
    WARNING Listed below are the system limitations for RearView Monitor. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The s ...

    Other materials:

    HVAC branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the A/C auto amp. for damage, bend and loose connection (unit side and connector side). 2.CHECK HARNESS FOR OPEN CIRCUI ...

    Power supply and ground circuit
    BCM BCM : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-67, "Wiring Diagram". 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. Is the fuse or fusible link blown? 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. ...

    Rear lower link & coil spring
    Removal and Installation Removal Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Loosen the rear lower link adjusting bolt and nut at the rear suspension member. Support the rear lower link with a suitable jack. Support the rear axle housing with a ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2025 Copyright www.nimainfo.com
    0.0108