Removal and Installation
REMOVAL
INSTALLATION
Installation is in the reverse order of removal.
U0100 lost communication (ECM A)
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
2.PERFORM DTC CONFIRMATION PROCEDURE
Start the en ...
Hazard switch
Component Function Check
1.CHECK HAZARD SWITCH SIGNAL BY CONSULT
CONSULT DATA MONITOR
Turn ignition switch ON.
Select "HAZARD SW" of BCM (FLASHER) DATA MONITOR item.
With operating the hazard switch, check the monitor status.
Diagnosis Procedure
1.CHECK HAZARD SWITCH SIGNAL I ...
Driving the vehicle
Continuously Variable Transmission (CVT)
WARNING
Do not depress the accelerator pedal
while shifting from P (Park) or N (Neutral)
to R (Reverse), D (Drive), or M
(Manual shift mode). Always depress
the brake pedal until shifting is completed.
Failure to do so could cause you
t ...