Nissan Maxima Service and Repair Manual: Multifunction switch

Removal and Installation

REMOVAL

Nissan Maxima. MULTIFUNCTION SWITCH

  1. Remove cluster lid D. Refer to IP-18, "Removal and Installation".
  2. Remove the four multifunction switch screws (A) and the multifunction switch (2) from cluster lid D (1).
    : Metal clip

INSTALLATION

Installation is in the reverse order of removal

    AV control unit
    Removal and Installation AV control unit AV control unit bracket (LH) AV control unit bracket (RH) A/C auto amp. Cluster lid C (with A/C and AV switch assembly attached) Clip ...

    Audio display unit
    Removal and Installation Audio display unit bracket Audio display unit Cluster lid D Multifunction switch Audio display unit bracket screws Audio display unit screws Metal Cli ...

    Other materials:

    Forward Emergency Braking (FEB) (if so equipped)
    WARNING Failure to follow the warnings and instructions for proper use of the FEB system could result in serious injury or death. The FEB system is a supplemental aid to the driver. It is not a replacement for the driver's attention to traffic conditions or responsibility to drive safel ...

    Magnet clutch
    Description SYSTEM DESCRIPTION A/C auto amp. controls A/C compressor operation by ambient temperature and signal from ECM. Low Temperature Protection Control A/C auto amp. will turn the A/C compressor ON or OFF as determined by a signal detected by ambient sensor. When ambient temper ...

    C1111 pump motor
    Description PUMP The pump returns the brake fluid stored in the reservoir to the master cylinder by reducing the pressure. MOTOR The motor drives the pump according to the signals transmitted by the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC CON ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2024 Copyright www.nimainfo.com
    0.013