Nissan Maxima Service and Repair Manual: Front door speaker

Removal and Installation

REMOVAL

Nissan Maxima. FRONT DOOR SPEAKER

  1. Remove the front door finisher. Refer to INT-18, "Removal and Installation".
  2. Remove the front door speaker screws (A).
  3. Disconnect the harness connector from the front door speaker (1) and remove.
  4. Remove the front door speaker spacer screws (B) and remove the front door speaker spacer (2).

INSTALLATION

Installation is in the reverse order of removal.

    Center speaker
    Removal and Installation REMOVAL Remove the center speaker grille, using a suitable tool. Remove the center speaker screws (A). Pull out the center speaker (1), disconnect the harness con ...

    Rear door speaker
    Removal and Installation REMOVAL Remove the rear door finisher. Refer to INT-21, "Removal and Installation". Remove the rear door speaker screws (A). Disconnect the harness c ...

    Other materials:

    P050A, P050e cold start control
    Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A or P050E is dis ...

    Thermostat and thermostat housing
    Removal and Installation Gasket Thermostat assembly (water inlet) WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the radiator cap. Slowly turn it a ...

    B260A ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. Ignition relay-1 (inside IPDM E/R) Ignition relay-2 (inside fuse block (J/B)) Front blower motor relay BCM checks any ignition relay ON request for consistency wi ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2024 Copyright www.nimainfo.com
    0.006